Minolta magicolor 330 Service Manual page 357

RRP 9.104 Exit-2 Roll Assembly (PL10.2.5)
Removal
1. Remove the Lower Exit Assembly (RRP 9.101).
2. Place the Lower Exit Assembly on a flat and stable work surface.
3. Remove the E ring securing the Spur Gear to the front of the Exit-2 Roll Shaft and remove the Gear.
4. Remove the E ring securing the Spur Gear to the rear of the Exit-2 Roll Shaft and remove the Gear.
5. Slide the Front and Rear Bearings off of the Exit-2 Roll Shaft.
6. Remove the Exit-2 Roll Assembly from the Lower Exit Assembly.
Replacement
1. Position the Exit-2 Roll Assembly so the three rubber rollers line up with the indentations in the slot in
the Lower Exit Assembly.
2. Reinstall the Exit-2 Roll Assembly into the slot in the Lower Exit Assembly.
3. Slide the Front and Rear Bearings onto the Exit-2 Roll Shaft and push the Bearings into the notches in
the Lower Exit Assembly.
4. Slide a Spur Gear onto the front of the Exit-2 Roll Shaft and use an E ring to secure the Gear to the
Shaft.
5. Slide a Spur Gear onto the rear of the Exit-2 Roll Shaft and use an E ring to secure the Gear to the
Shaft.
6. Reinstall the Lower Exit Assembly (RRP 9.101).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-213