Minolta magicolor 330 Service Manual page 157

RRP 9.4 Rear Cover (PL1.1.31)
Removal
1. Open the Upper Exit Cover.
2. Remove the Harness Cover.
3. Slide the Main Paper Handling Assembly a few inches out of the printer.
4. Remove the six screws securing the Rear Cover to the printer frame and remove the Cover.
Replacement
1. Open the Upper Exit Cover.
2. Slide the Main Paper Handling Assembly a few inches out of the printer.
3. Reinstall the Rear Cover onto the printer frame.
4. Reposition the Cover so the six screw holes in the Cover line up with the five screw holes in the printer
frame.
5. Use five screws to secure the Rear Cover to the printer frame.
6. Slide the Main Paper Handling Assembly into the printer.
7. Reinstall the Harness Cover.
8. Close the Upper Exit Cover.
SER459F
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-13