Section 11 - Parts List - Minolta magicolor 330 Service Manual

Parts List

Section 11 - Parts List

Using the Parts List
1. The numbers shown in each illustration correspond to the parts list number for that illustration.
2. Throughout this manual, parts are identified by the prefix "PL", followed by a number, a decimal point, and
another number. For example, PL3.12 means the part is item 12 of parts list 3.
3. The capital letters "C", "E", "KL", and "S" shown in an illustration stand for C-ring, E-ring, Clamp, and Screw,
respectively.
4. A shaded triangle t in an illustration indicates the item is part of an assembly.
5. The notation "with X~Y" following a part name indicates an assembly that is made up of components X through
Y. For example, "1 (with 2~4)" means part 1 consists of part 2, part 3, and part 4.
*
6. An asterisk following a part name indicates the page contains a note about this part.
7. The notation "J1<>J2 and P2" is attached to a wire harness. It indicates that connector jack 1 is attached to one
end of the wire harness and connector jack 2 is attached to the other end that is plugged into plug 2.
11-2 magicolor 330 - Base Engine Service Manual