Minolta magicolor 330 Service Manual page 231

RRP 9.41 Pre-Registration Clutch (PL5.2.8)
Removal
1. Remove the Main Paper Handling Assembly (RRP 9.36).
2. Remove the Pre-Registration Chute Assembly (RRP 9.38).
3. Turn the Main Paper Handling Assembly over and disconnect P/J 95 from the Pre-Registration Clutch.
4. Remove the two screws securing the Pre-Registration Gear Assembly to the Main Paper Handling
Assembly and remove the Gear Assembly (Figure 2).
5. Remove the E rings securing the Pre-Registration Clutch and the Pre-Registration Gear to the Pre-
Registration Support and remove the Support (Figure 1).
6. Slide the Pre-Registration Gear off of the Shaft.
7. Slide the Pre-Registration Clutch off of the Pre-Registration Shaft.
Replacement
1. Slide the Pre-Registration Clutch onto the Shaft, making sure you slide the key of the Clutch into the
tab on the Main Paper Handling Assembly.
2. Slide the Pre-Registration Gear onto the Shaft.
3. Reinstall the Registration Support, making sure you install the open end of the Support onto the Gear
12 shaft.
4. Use E rings to secure the Pre-Registration Clutch and the Pre-Registration Gear to the Pre-Registra-
tion Support.
5. Reconnect P/J 95 and route the wire away from any gears.
6. Reinstall the Pre-Registration Gear Assembly to the Main Paper Handling Assembly and use two
screws to secure the Gear Assembly.
7. Reinstall the Pre-Registration Chute Assembly (RRP 9.38).
8. Reinstall the Main Paper Handling Assembly (RRP 9.36).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-87