Minolta magicolor 330 Service Manual page 165

RRP 9.8 Right Cover Assembly (PL1.1.50)
Removal
1. Slide the Main Paper Handling Assembly a few inches out of the printer.
2. Open the Front Cover.
3. Remove the two screw caps that are covering the heads of the two Right Cover screws.
4. Remove the two screws securing the Right Cover to the printer frame.
5. Slide the Cover to the rear of the printer and remove the Cover.
Replacement
1. Slide the Main Paper Handling Assembly a few inches out of the printer.
2. Open the Front Cover.
3. Insert the two metal tabs located at the rear of the Cover into the two slots in the printer frame.
4. Slide the Cover to the front of the printer.
5. Press the Cover against the printer frame, making sure the positioning tab located at the top front of
the Cover fits into the hole in the printer frame.
6. Reposition the Cover so the two screw holes in the Cover line up with the two screw holes in the frame.
7. Use two screws to secure the Cover to the printer frame.
8. Reinstall the screw caps to cover the screw heads.
9. Close the Front Cover.
10. Slide the Main Paper Handling Assembly into the printer.
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-21