Page 3
This kit includes all the hardware necessary to convert a magicolor 6100 DeskLaser to a magicolor 6100 Crown Print System. MINOLTA-QMS Crown is a proprietary, multitasking printer operating system, which allows MINOLTA-QMS to adapt advanced printer software to the evolving printing needs of users in many different environments.
Page 4
Converting your magicolor 6100 DeskLaser printer to a magicolor 6100 Crown Print System involves two steps: Replacing the controller board. Applying the new product labels. Caution : It’s very important to protect the printer controller board from electrostatic damage while performing this conversion.
Page 5
Remove the controller board from the printer. Loosen two screws, one on each end of the I/O connector panel, and, using the tab on the lower side of the connector panel, pull the controller board from the printer. Position the controller board on a flat surface so the controller board lies flat and the I/O connector panel is facing you.
Page 6
Time-of-Day Clock, install them now. Refer to the appropriate chapter(s) of your magicolor 6100 Print System Options manual for instructions. 10 Reinstall the controller board into the printer. Gently slide the controller board into the printer until it is fully seated, and then tighten the two screws.
Page 7
After the printer warms up, a startup page similar to the one shown below prints. The startup page indicates that the printer has successfully been converted from a magicolor 6100 DeskLaser to a magicolor 6100 Crown Print System. Verify that the memory and options that were installed are correctly identified on the startup...
Page 8
Remove existing labels and apply the magicolor 6100 logo and the dataplate label to the printer as shown in the following diagram:...
Page 9
Connecting Your MINOLTA-QMS Print System manual for instructions on installing the printer driver. If you don’t have a magicolor 6100 DeskLaser printer connected to you PC or net- work, you can remove the installed printer driver. To do so: From the Start menu select Programs, and then select MINOLTA-QMS Printer Utilities.