Rrp 9.1 Front Cover Assembly - Minolta magicolor 330 Service Manual

RRP 9.1 Front Cover Assembly (PL1.1.1)
Removal
1. Slide Tray 1 halfway out of the printer.
2. Open the Front Cover and let it rest on top of Tray 1.
3. Remove the two screws securing the two Hinge Plates to the Front Cover and remove the Plates.
4. Two the two screws securing the two Front Cover Supports to the printer frame.
5. Remove the Front Cover Assembly from the printer.
Replacement
1. Slide Tray 1 halfway out of the printer.
2. Position the Front Cover Assembly as shown in the figure, making sure the Cover lip is under the two
metal hinges that are protruding from the printer.
3. Let the Front Cover Assembly rest on top of Tray 1.
4. Reinstall each of the two Hinge Plates so one end of each Plate is over the metal hinges.
5. Align each Plate with the positioning tabs and screw holes on the Front Cover Assembly.
6. Use two screws to secure the two Hinge Plates to the Front Cover Assembly, but tighten the screws
only halfway.
7. Reposition the Cover and the Plates, so the notches at the end of each Plate fit over each of the metal
hinges.
8. Tighten the two screws to secure the Hinge Plates to the Front Cover.
9. Reattach the two Front Cover Supports to the frame and use two screws to secure the Supports.
10. Close and open the Front Cover Assembly, making sure the Cover moves freely and without binding.
11. Slide Tray 1 back into the printer.
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-7