Minolta magicolor 330 Service Manual page 389

RRP 9.120 High Voltage Power Supply (HVPS) (PL13.1.2)
Removal
1. Remove the Rear Cover (RRP 9.4).
2. Disconnect P/J 41 and P/J 42 from the bottom of the HVPS.
3. Disconnect the five xerographic voltage P/Js from the HVPS.
4. Remove the four screws securing the HVPS to the HVPS Brackets and remove the HVPS.
Replacement
1. Position the HVPS so xerographic connections A and C are at the top of the PWB.
2. Reinstall the HVPS onto the HVPS Brackets, making sure that none of the wire harnesses are trapped
between the HVPS and the printer frame.
3. Use four screws to secure the HVPS to Brackets.
4. Reconnect the five xerographic voltage P/Js to the HVPS.
5. Reconnect P/J 41 and P/J 42 to the bottom of the HVPS.
6. Reinstall the Rear Cover (RRP 9.4).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-245