Used Opc End Of Life - Minolta magicolor 330 Service Manual

3.16 - Error Message: Used OPC End of Life
The OPC Drum installed is not new.
Logic control on the MCU PWB detected that the installed OPC Drum is not new.
Step
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially or
completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Wiring and connectors linking the components
1
Replace the OPC Drum (RRP 9.48) with a Cartridge that is recom-
mended for use with this printer.
Does the error message still appear?
2
MCU PWB INSPECTION
1. Switch off the printer.
2. Follow RRP 9.123 to access the MCU PWB.
3. Disconnect P/J 16 from the MCU PWB.
4. Reconnect P/J 16 to the MCU PWB.
5. Switch on the printer.
Does the error message still appear?
3
Replace the MCU PWB (RRP 9.123)
Does the error message still appear?
magicolor 330 - Base Engine Service Manual
Actions and Questions
Primary FIPS: Error Messages
Yes No
Go to step 2 Problem
solved
Go to step 3 Problem
solved
Go to suspect Problem
components Solved
3-19