5.8 - Spot Deletions - Minolta magicolor 330 Service Manual

Primary Fault Isolation Procedures

5.8 - Spot Deletions

RS508X
Step
PAPER INSPECTION
Inspect the paper that is loaded in the paper tray.
1
Is the paper wrinkled, dimpled, or show any signs of having a
high moisture content?
XEROGRAPHIC INSPECTION
1. Generate a test print and slide the Fuser Assembly out of the
printer just before the sheet of paper enters the Fuser.
2
2. Remove the Xerographic Cartridge (RRP 9.48).
3. Inspect the image on the Drum.
Is there a normal test print image, without any spot deletions,
visible on the drum?
IBT INSPECTION
Inspect the image on the surface of the IBT?
3
Is there a normal test print image, without any spot deletions,
visible on the surface of the IBT?
2ND TRANSFER INSPECTION
1. Generate a test print and slide the Fuser Assembly out of the
printer just before the sheet of paper enters the Fuser.
4
2. Inspect the image on the sheet of paper just before the paper
enter the Fuser.
Is there a normal test print image, without any spot deletions,
visible on the sheet of paper?
5-18
PROBLEM
There are areas of the image that are extremely light or are missing entirely. These missing
areas form spots that are localized to small areas of the page. THE PRINTER DIS-
PLAYS NO ERROR MESSAGE.
• MCU PWB (RRP 9.123)
• Controller PWB (RRP 9.129)
• LVPS (RRP 9.119)
• ROS Assembly (RRP 9.47)
Actions and Questions Yes
Load fresh, dry
paper.
Go to step 3
Go to step 4
Go to step 5
magicolor 330 - Base Engine Service Manual
No
Go to step 2
Go to step 7
Replace the
Transfer
Assembly
(RRP 9.71)
Replace the
2ND BTR
Assembly
(RRP 9.75)