Minolta magicolor 330 Service Manual page 335

RRP 9.93 Oil Cam Solenoid (PL9.3.21)
Removal
1. Remove the Main Fuser Assembly (RRP 9.81).
2. Place the Fuser Tray on a flat and stable work surface.
3. Remove the two screws securing the Fuser Rear Rail to the Fuser Tray and pull the Rail away from
Tray (Figure 1).
4. Disconnect P/J 73 from the Oil Cam Solenoid.
5. Remove the two screws securing the Oil Cam Solenoid to the Fuser Tray and remove the Solenoid.
Replacement
1. Line up the screw holes in the Oil Cam Solenoid with the screw holes in the Fuser Tray.
2. Reinstall the Oil Cam Solenoid onto the Fuser Tray and use two screws to secure the Solenoid to the
Tray.
Make sure the Solenoid arms rest on the Cam as shown in Figure 2.
3. Reconnect P/J 73 to the Oil Cam Solenoid.
4. Line up the positioning hole and screw holes in the Fuser Rear Rail with the positioning tab and screw
holes in the Fuser Tray.
5. Reinstall the Fuser Rear Rail onto the Fuser Tray and use two screws to secure the Rail to the Tray.
6. Reinstall the Main Fuser Assembly (RRP 9.81).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-191