Part Names & Functions Precautions regarding using the NETWORK connector
Precautions regarding using the NETWORK connector
The NETWORK connector on the rear panel of each component of the RIVAGE PM10 system will be supported by a future update.
Do not connect these connectors to any devices other than supported devices (such as a computer that is used to update the firmware).
Otherwise, unexpected input of communications traffic may jeopardize system operation.
In particular, never connect the NETWORK connectors on multiple components to the same network switch.
These connectors are usually connected to each other via the system network. Therefore, connecting them to the network switch will generate a loop that could prevent normal system communications.
NETWORK connector on each component
(rear panel)
RPio622
(rear panel)
DSP-R10
(rear panel)
CS-R10
Do NOT connect multiple components to the network switch