Yamaha RIVAGE PM10 Operation Manual page 54

System Setup  SYSTEM CONFIG
5 PHASE button
Switches the phase of the input signal.
NOTE
This is a parameter within the I/O rack. It is different than the Ф parameter within the channel
module of the control surface.
6 M/S button
Switches the M/S decoder on or off for each pair of channels.
7 S-GAIN knob
Adjusts the side gain of M/S.
8 Tabs
Switch the input and output display in units of eight channels.
RY16-AE OUTPUT1-8/OUTPUT9-16
AES/EBU OUTPUT1-8 of the control surface's rear panel
1
2
3
4
5 6
7
8
1 Patch indication
Indicates the channel that is patched.
2 DELAY button
Switches the output delay on or off.
3 Delay time knob
Sets the delay time of the output port. If you press this when it is selected, the DELAY TIME
popup window will appear. The delay time value is shown above the knob in millisecond units,
and below the knob in the units that are selected in the DELAY SCALE popup window.
NOTE
If the scale is set to ms, the delay time value above the knob is not shown.
4 PHASE button
Switches the phase of the output signal.
5 SRC button
Switches the sampling rate converter on/off for each pair of channels.
54
CONTENTS FUNCTION MAP
9
RIVAGE PM10 Operation Manual
FAQ