CH Parameter INSERT/D.OUT (Insert/Direct Out)
Patching multiple Direct Outs simultaneously
Press the PATCH button on the menu bar to access the PATCH screen.
This screen includes several pages, which you can switch between using the tabs located at the
top of the screen.
Press the DIRECT OUT tab to access the DIRECT OUT page.
The window contains the following items.
Channel select list
Enables you to select the channels that you want to view on the screen.
Channel select knob
Enables you to select the channel that you want to use for Direct Out.
This area displays the channel name of each input channel that will be a patch source.
Output patch number indication
Indicates the number of Direct Outs assigned to each input channel.
Category select list
Select the ports that you want to view on the screen.
OUTPUT COMPONENT/SLOT/CH (output components/slots/channels)
From the top, this section indicates the type of the output component, slot number, and
channel number for the output port. The abbreviations displayed in the output component
column have the following meaning.
• Mx ...................................I/O rack (x is the UNIT ID number)
• CONSOLE .....................Control surface
• DSP .................................DSP engine
DIRECT OUT ASSIGN (assign)
Indicates the number of channels assigned to each port.
This grid enables you to patch input channels (vertical columns) to output ports (horizontal
lines). Currently-patched grids are indicated by white squares. Press or click a desired grid to
set or disable the patch.
Press the continuous patch
range of intersecting channels.
If you press the continuous patch
button again to confirm the selected continuous patches. Press the
to revert the continuous patches to the previous state.
Port select knob
Selects the port that will be used for Direct Out.
CLEAR ALL button
Press this button to clear all selections.
Use the port select knob to display the ports of the slot that will be used for REC
Use the channel select knob to display channels.
Press a grid cell to patch the corresponding channel.
button, and then rotate the select knobs (2) ()) to patch the
button and the
button will appear.
RIVAGE PM10 Operation Manual