Yamaha RIVAGE PM10 Operation Manual page 52

System Setup  SYSTEM CONFIG
■ Editing the internal parameters of each component
1.
Press a parameter settings popup button to access the parameter settings
popup window of each component.
2.
Edit the parameters as needed.
The parameter editing screens that appear are as follows
RY16-ML-SILK
%
1
2
4 5
3
6 7
8 9
)
!
@
#
$
1 Patch indication
Indicates the channels that are patched.
2 +48V button
Switches phantom power (+48V) on or off.
3 A.GAIN knob
Indicates the HA analog gain setting. You can use the screen encoders to make adjustments. If
gain compensation is on, an indicator shows the analog gain position at the time that gain
compensation was turned on.
4 Meter (Pre GC)
This meter indicates the level of signals after passing through analog gain (before GC).
5 Meter (channel input)
This meter indicates the level of signals after passing through GC (before D.GAIN).
6 GC (GAIN COMPENSATION) button
Switches the gain compensation on or off for that channel.
7 PHASE button
Switches the phase of the input signal.
NOTE
This is a parameter within the I/O rack. It is different than the Ф parameter within the channel
module of the control surface.
8 SILK ON button
Switches Silk on or off.
9 RED/BLUE selection button
Switches the character of Silk processing between the powerful BLUE and the sparkling RED.
) SILK [TEXTURE] knob
Adjusts the TEXTURE parameter of Silk.
! HPF button
Toggles the high pass filter on or off for each port.
NOTE
This is a parameter within the I/O rack. It is different than the HPF within the channel module of
the control surface.
@ FREQUENCY knob
Sets the HPF cutoff frequency.
# M/S button
Switches the M/S decoder on or off for each pair of channels.
$ S-GAIN knob
Adjusts the side gain of M/S.
% Tabs
Switch the display in units of eight channels.
52
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual
FAQ