Download  Print this page

Advertisement

System Setup  SYSTEM CONFIG

SYSTEM CONFIG

In SYSTEM CONFIG you can specify the type and number of components that comprise the
RIVAGE PM10 system, and the audio channels that are assigned to the TWINLANe network. As
necessary, you can also set the internal parameters of each component. You can also view and set the
overall operating state of the entire system. SYSTEM CONFIG allows you to make settings offline if
you are setting up in a location where the actual devices are not yet connected. The components will
be recognized automatically once they are connected, and you will be able to control the parameters
for those actual devices.
Online settings
The procedure for making online settings is described below.
1. Synchronizing the settings data between components
2. Specifying the number of channels used by the other DSP engine
3. Assigning channels to the TWINLANe network
4. Editing the internal parameters of each component
■ Synchronizing the settings data between components
About the need for synchronization
Control surface
DSP engine
Mixing data
Mixing data
The control surface and DSP engine each maintain mixing data, and synchronize this data via the
network.
This means that when connecting a network, it is necessary to specify whether synchronization is
performed on the basis of the control surface's data or the DSP engine's data.
I/O racks maintain parameters such as HA gain and gain compensation, and you must likewise
specify the unit associated with the data used as the basis of synchronization.
(page
46)
(page
47)
(page
52)
I/O rack
I/O rack
HA gain
Gain compensation settings etc.
1.
When you finish connecting the system, turn on the power of each device other
than the output devices (such as amps) as described in the RIVAGE PM10
System Setup Guide.
When the control surface detects that a new device (DSP engine, I/O rack) is connected, it
determines whether data synchronization is needed; if data synchronization is needed, the
DEVICE SYNC popup window will appear.
2.
When a popup window appears, specify the direction of data synchronization.
DSP  CS or CS  DSP
DSP  I/O or I/O  DSP
3.
Press the SYNC button.
Data synchronization is completed, and the line indicating synchronization is displayed in
green.
NOTE
If there has been no change in the internal data of each component since the previous
synchronization, synchronization occurs automatically, so the DEVICE SYNC popup window
does not appear.
45
CONTENTS
FUNCTION MAP
RIVAGE PM10 Operation Manual
FAQ

Advertisement

Table of Contents

   Related Manuals for Yamaha RIVAGE PM10

Comments to this Manuals

Symbols: 0
Latest comments: