Plug-ins Controlling the parameters of a plug-in
BAND WIDTH knob
Specifies the width of the band controlled by the high-range filter.
Turning the knob toward the right (Broad) makes the band wider and also lowers the peak
level. This affects only the response of the boost.
HIGH FREQUENCY knob
Adjusts the frequency of the high-range filter. This affects only the response of the boost.
(HIGH) BOOST knob
Adjusts the amount of boost for the frequency region specified by the HIGH FREQUENCY
(HIGH) ATTEN knob
Sets the amount of attenuation applied to the frequency band specified by the ATTEN SEL
(HIGH) ATTEN SEL knob
Switches the frequency band to which attenuation is applied by the ATTEN knob.
■ Dynamic EQ
Dynamic EQ is a newly developed equalizer; it does not emulate any specific model. It provides a
filter through which the same frequency band as the EQ is extracted to a sidechain, allowing the EQ
gain to be varied dynamically when a specific band of the input signal becomes louder or softer, so
that EQ is applied just as you might apply a compressor or expander to a specific frequency band.
For example, by using this on a vocal as a de-esser, you can apply EQ to only that specific band when
sibilants and high-frequency scratchy sounds reach an obtrusive level, obtaining a natural sound
without impairing the original character. There are two full-band Dynamic EQ units, so you can use
them on a variety of material.
BAND ON/OFF button
Switches the corresponding band on/off.
SIDECHAIN CUE button
If this button is on, the sidechain signal is sent to the CUE bus for monitoring. In this case, the
graph shows the response of the sidechain filter.
SIDECHAIN LISTEN button
If this button is on, the sidechain signal linked to the dynamics is output to the bus (e.g.,
STEREO bus or MIX/MATRIX bus) to which the inserted channel is being sent. In this case,
the graph shows the response of the sidechain filter.
RIVAGE PM10 Operation Manual