Yamaha RIVAGE PM10 Operation Manual page 85

Monitor  CUE
6 DCA CUE field
This section enables you to make settings related to DCA cue.
• Cue point select button
Sets the cue point for DCA to PRE PAN (immediately before PAN) or POST PAN
(immediately after PAN).
• DCA TRIM knob
Indicates the monitor level of cue signals from a DCA. Use the screen encoder to adjust the
value.
• UNITY button
Turn on this button to monitor signals at the same volume level that was obtained when the
master level for each DCA was set to 0 dB (unity gain).
7
OUTPUT CUE field
Enables you to make settings related to output channel cue.
• Cue point select button
Enables you to set the cue point for the output channel to PFL (immediately before fader) or
AFL (immediately after fader).
• PFL TRIM knob
Indicates the monitor levels when PFL is selected. Use the screen encoder to adjust the value.
8 Meters
This field indicates the output level of the cue L/R channels.
9 CUE OUT MODE select button
You can output the cue signal in stereo or monaural.
) INSERT button
Press this button to display the window to insert plug-ins to the cue signal.
! INSERT ON button
Switches the plug-in insert on or off. The currently-specified plug-in is displayed to the left of
the INSERT ON button.
@
EQ field
• EQ graph
This field graphically indicates the approximate response of the EQ. Press this field to open
the window, in which you can set the EQ parameters.
• EQ ON button
Switches the EQ on or off.
# CUE OUT PATCH button
Press this button to access the PORT SELECT popup window, in which you can select output
ports to patch to the cue out L/R channels.
$ CUE OUTPUT button
Switches cue output on or off.
% CUE LEVEL knob
Indicates the cue output level. Use the screen encoder to adjust the value.
^
ACTIVE CUE indicator
Lights to indicate the type of cue currently being monitored.
&
CLEAR CUE button
Press this button to clear all cue selections simultaneously.
85
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual
FAQ