Plug-ins Controlling the parameters of a plug-in
FILTER TYPE buttons
Switch the type of the main bus equalizer and sidechain filter. The main EQ and sidechain
filter are linked as follows.
Specifies the frequency that is controlled by the equalizer and the sidechain filter.
Specifies the Q (steepness) of the equalizer and the sidechain filter.
Turning the knob toward the right will broaden the region affected by the equalizer and
Specifies the threshold value at which the processing effect begins to apply.
Specifies the ratio of boost/cut for the input signal.
Turning this toward the right applies boost, and turning it toward the left applies cut; turning
the knob all the way in either direction produces the maximum effect.
Enable you to select one of three settings for the attack time and release time at which
compression or boost is applied.
FAST produces a fast attack and fast release, SLOW produces a fast attack and slow release, and
AUTO automatically adjusts the attack and release according to the frequency region.
Specify whether processing operates when the sidechain signal exceeds the threshold value
(ABOVE) or when it falls below it (BELOW).
EQ GAIN meter
Indicates the gain of the dynamically changing EQ.
Indicates the level of the sidechain signal, referenced to the threshold level.
Indicates the response of the equalizer.
Normally this area shows the reference EQ graph, which indicates the frequency and depth;
and the dynamic EQ graph, which indicates the response of the dynamically changing EQ.
If SIDECHAIN CUE or SIDECHAIN LISTEN is on, this graph shows the response of the
Dynamic EQ graph
Reference EQ graph
Sidechain filter graph
RIVAGE PM10 Operation Manual