Yamaha RIVAGE PM10 Operation Manual page 56

System Setup  SYSTEM CONFIG
MY CARD OUTPUT
1
2
3
4
5
6
1 Patch indication
Indicates the channel that is patched.
2 DELAY button
Switches the output delay on or off.
3
Delay time knob
Sets the delay time of the output port. If you press this knob when it is selected, the DELAY
TIME popup window will appear. The delay time value is shown above the knob in
millisecond units, and below the knob in the units that are selected in the DELAY SCALE
popup window.
NOTE
If the scale is set to ms, the delay time value above the knob will not be shown.
4 PHASE
Switches the phase of the signal that is output.
5 GAIN knob
Adjusts the output gain of the output port. You can use the screen encoders to make
adjustments. Adjust the setting in 1.0 dB units by turning the knob, or adjust the setting in
0.1 dB units by turning the knob while pressing it. The current value is shown immediately
below the knob.
7
6 Level meters
Indicates the output level of the signal after level adjustment.
7 Tabs
Switch the input and output display in units of eight channels.
56
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual
FAQ