CH Parameter INSERT/D.OUT (Insert/Direct Out)
INSERT/D.OUT popup window (12CH/D.OUT)
This window is convenient if you want to make settings for multiple channels at one time.
DIRECT OUT ON button
Switches direct out on/off. The currently-specified Direct Out point is indicated in the lower
part of the button.
DIRECT OUT point
Enables you to select the signal extraction point as PRE FILTER, PRE EQ, PRE DYNA1,
PRE DYNA2, PRE FADER, POST FADER, or POST ON.
DIRECT OUT PATCH popup button
Indicates the currently-selected port. If nothing is selected, the button indicates "----". Press
this button to access the patch window.
DIRECT OUT LEVEL knob
Indicates the output level of the Direct Out. You can press this knob and then use the screen
encoder or the [TOUCH AND TURN] knob to adjust the level.
Press the DIRECT OUT PATCH popup button to access the DIRECT OUT PATCH
In the DIRECT OUT PATCH popup window, select the output port that you want
to use for Direct Out, and then press the CLOSE button.
You will return to the INSERT/D.OUT popup window.
Use the DIRECT OUT point to switch the point from which the Direct Out signal is
Use the DIRECT OUT LEVEL knob to adjust the output level of the Direct Out.
Press the DIRECT OUT ON button to turn it ON.
Direct output is now enabled. Adjust the input level and other settings on the external device
If necessary, make Direct Out settings for other channels in the same way.
RIVAGE PM10 Operation Manual