Using The Faders To Adjust The Sends (Sends On Fader Mode) - Yamaha RIVAGE PM10 Operation Manual

CH Parameter  SENDS TO/SENDS FROM

Using the faders to adjust the sends (SENDS ON FADER mode)

You can use the top panel faders to adjust the signals that are sent from a specific channel to the
MIX/MATRIX buses.
1.
Verify that an output port is assigned to the MIX/MATRIX bus to which the
signal is sent, and that the corresponding output port is connected to the
monitor system or an external effect.
2.
Press the SENDS ON FADER button on the menu bar or press the top panel
[SENDS ON FADER] key to access the SENDS ON FADER popup window.
The RIVAGE PM10 system switches to SENDS ON FADER mode, and the SENDS ON
FADER popup window appears. The faders in the Channel Strip section move to indicate the
send level of the signals that are routed from each channel to the currently-selected MIX/
MATRIX bus. The [ON] keys also change to the SEND ON status.
2 1 3
4
1 SEND TO indication
Indicates the currently-selected send destination. This is linked with the on-screen selected
channel/parameter.
2 Tabs
Switch between MIX and MATRIX.
3 MIX/MATRIX bus select buttons
You can press a button to select the send destination. This is linked with the on-screen selected
channel/parameter.
4
FADER LEVEL ON field
This field indicates the content that is selected by the PARAMETER SHOWN ON SoF
SCREEN setting in PREFERENCES
SEND LEVEL.
3.
Press a tab to switch between MIX and MATRIX.
4.
Use the MIX/MATRIX select buttons to select the send-destination MIX/MATRIX
bus.
NOTE
If you press the currently-selected MIX/MATRIX select button once again, cue monitor turns on
for the corresponding MIX/MATRIX channel. This method is convenient when you want to
monitor the signal that is being sent to the selected MIX/MATRIX bus.
5.
Using the faders of the top panel Channel Strip section, adjust the send level to
the selected MIX/MATRIX bus from the channels that are recalled (rolled out) to
the layer.
6.
Repeat steps 4–5 to adjust the send levels for other MIX/MATRIX buses in the
same way.
7.
When you finish adjusting the MIX/MATRIX send levels, press the [SENDS ON
FADER] key or the SENDS ON FADER button.
The main area display returns to its previous state, and the RIVAGE PM10 system exits SENDS
ON FADER mode and returns to normal mode.
NOTE
If you press the × button in the upper right of the screen, SENDS ON FADER mode will be
maintained when you close the screen. To exit SENDS ON FADER mode, perform step 7.
133
CONTENTS FUNCTION MAP
(page 224). You can select FADER LEVEL, SEND PAN, or
RIVAGE PM10 Operation Manual
FAQ