The RIVAGE PM10 system features two monitor outputs (MONITOR A and MONITOR B). You
can select the monitor source and set the output level for each monitor output individually. There
are the following features:
• You can specify, mix and monitor up to eight channel signals.
• You can select not only channel or bus signals, but signals directly from input patches as monitor
• You can assign and switch out up to eight combinations of monitor signals.
• The monitor section provides an 8-band parametric EQ specialized for monitoring.
Using the Monitor function
■ Controlling the Monitor function via the UTILITY section
MONITOR A/B knobs
Adjust the output level of the
■ Controlling the Monitor function via the MONITOR screen
In this screen, you can select desired monitor sources to monitor them from the PHONES A/B
output jacks or external monitor speakers.
Connect your monitor system to the OMNI OUT jacks or AES/EBU jack on the
Monitor signals can be sent to any desired output jack or output channel. If you are monitoring
through headphones, make sure that your headphones are connected to the front panel
PHONES A/B output jacks.
Press the MONITOR button on the menu bar to access the MONITOR screen.
The MONITOR field on the MONITOR screen enables you to check the current monitoring
settings, and turn monitoring on or off.
MONITOR popup button
Enables you to access the MONITOR SETTINGS popup window, in which you can make
detailed monitoring settings. Select MONITOR A or B as the control target, and set the
parameters in the corresponding field.
Enables you to make settings for the Dimmer function, which temporarily attenuates monitor
• DIMMER LEVEL knob
Adjusts the amount by which the monitor signals will be attenuated when the dimmer is on.
RIVAGE PM10 Operation Manual