Download  Print this page

Advertisement

Scene Memory  Outputting a control signal to an external device in tandem with scene recall (GPI OUT)
4.
In the channel select field, select the channels to which the Fade effect will be
applied (multiple selections are allowed).
The [SEL] keys for the selected channels or DCAs will light, and those channels or DCAs will
be highlighted green in the channel display field. You can cancel the selection by pressing the
lit [SEL] key once again to turn it off.
5.
Use the screen encoder that corresponds to the FADE TIME knob, or use the
[TOUCH AND TURN] knob to adjust the fade time.
The range is 0.0 sec – 60.0 sec.
When you finish setting the fade time, press the OK button to close the FADE TIME setup
window.
NOTE
The fade time you specify here is used for all channels/DCAs selected in step 4.
6.
Press the FADE button to enable the Fade function.
You can turn the Fade function on or off individually for each scene.
NOTE
Scenes for which the Fade function is enabled are marked by a "FADE" indicator in the STATUS
field of the SCENE LIST window (COMMENT tab).
7.
Recall a scene for which the Fade function is turned on.
The faders will begin to move immediately after Recall occurs, and will reach the values of the
recalled scene over the course of the specified fade time.
NOTE
• By touching a moving fader, you can stop the fade operation of the fader at that point.
• If you recall the same scene while faders are moving, the faders of all channels and DCAs will
move immediately to their target positions.
Outputting a control signal to an external
device in tandem with scene recall (GPI OUT)
A control signal can be output to an external device connected to the GPI connector of the RIVAGE
PM10 system when you recall a specific scene. Proceed as follows.
NOTE
For more information about GPI OUT settings, refer to
1.
Press the SCENE field on the menu bar to access the SCENE LIST screen.
2.
Press the GPI tab at the top of the SCENE LIST screen.
The GPI field will appear in the right half of the SCENE LIST screen.
1
GPI button
If this button is on and the selected scene is recalled, a control signal will be output.
2
SET popup button
Press this button to access a popup window, in which you can specify the control signal output
from each GPI OUT.
3
GPI PARAMETER display section
In this section, indicators show the status of the GPI settings specified for each scene.
211
CONTENTS
FUNCTION MAP
"Using GPI
OUT"
(page
244).
1
2
3
4
RIVAGE PM10 Operation Manual
FAQ

Advertisement

Table of Contents

   Related Manuals for Yamaha RIVAGE PM10

Comments to this Manuals

Symbols: 0
Latest comments: