Yamaha RIVAGE PM10 Operation Manual page 95

Monitor  TALKBACK
3.
Connect a mic to the TALKBACK jack on the front panel, and then rotate the
TALKBACK gain knob to adjust the input sensitivity of the mic signal.
The meter in the TALKBACK IN field indicates the input level of the mic connected to the
TALKBACK jack. Turn phantom power on or off, and set the phase to normal or reverse, as
required by the connected mic.
4.
If you want to use an input jack other than the TALKBACK jack as supplementary
input for talkback, follow the steps below.
4
-1. Press the INPUT TO TALKBACK patch button to open the INPUT PATCH
popup window.
4
-2. Press the button for the input that you want to use for talkback.
You can select only one input at a time.
4
-3. Use the GAIN knob and level meter in the INPUT TO TALKBACK field to
adjust the input level of the connected mic.
NOTE
The PAD will be switched on or off internally when the HA gain is adjusted between +17 dB
and +18 dB.
Keep in mind that noise may be generated when using phantom power if there is a difference
between the Hot and Cold output impedance of an external device connected to the INPUT
jack.
5.
Press the tab to access the TALK GROUPS popup window.
1
1
DEFINE 1–8 buttons
Press these buttons to access the bus selection popup window, in which you can select the
signal destination.
6.
Press the target DEFINE button to access the TALKBACK ASSIGN popup window.
95
CONTENTS FUNCTION MAP
1
RIVAGE PM10 Operation Manual
FAQ