Download  Print this page

Advertisement

CH Parameter  SENDS TO/SENDS FROM
SENDS FROM popup window
2
3
4
5
6
1
Send-source select button
Indicates the currently-selected send source. You can use the –/+ buttons at left and right to
switch to adjacent channels. You can use the << / >> buttons to switch in steps of 12 channels.
This indication is linked with the on-screen selected channel.
2
Bus indication
Shows the send-destination bus. Use the [MIX]/[MATRIX] keys to switch the send-
destination selection. You can also switch this by holding down the [SHIFT] key and pressing
the meter area display section.
3
PRE button
Selects either PRE or POST as the send point of the signal that is sent to each bus. If a button is
lit, the send point is set to PRE.
4
SEND ON button
This button switches send to each bus on/off.
5
SEND PAN/BALANCE knob
Adjusts the pan/balance when the send-destination bus is stereo. If the bus is monaural or is
set to FIXED, this knob will not be shown.
If the send source is monaural, the knob adjusts pan.
If the send source is stereo, the knob adjusts balance.
1
6
SEND LEVEL knob
Adjusts the send level to the corresponding bus. If the send-destination bus is set to FIXED,
this knob will not be shown.
3.
Use the SEND ON button to switch on/off the signal that is sent from the
currently-selected channel to the MIX or MATRIX bus.
4.
If necessary, use the PRE button to select the send point of the signal that is sent
to the MIX or MATRIX bus.
NOTE
• You can flexibly select the send point for each channel
• The PRE button is not shown for a FIXED-type MIX bus.
131
CONTENTS
FUNCTION MAP
(page
67).
RIVAGE PM10 Operation Manual
FAQ

Advertisement

Table of Contents

   Related Manuals for Yamaha RIVAGE PM10

Comments to this Manuals

Symbols: 0
Latest comments: