Yamaha RIVAGE PM10 Operation Manual page 41

Screen Overview  About the OVERVIEW screen
Digital gain parameters
1
DIGITAL GAIN knob
Indicates the digital gain value. Use the screen encoder to adjust the
digital gain. If the Gain Compensation function is turned on, this knob
will adjust the level of the signal input to the input channel.
2 OVER indicator
Lights when a signal at the input port or from the rack output is
clipping. This indicator is available only if an input channel is selected.
3
indicator
Indicates the phase setting for each channel.
NOTE
You can display either analog gain or digital gain in the OVERVIEW screen by using the GAIN
SHOWN ON OVERVIEW SCREEN setting on the PREFERENCES screen.
■ SILK field
This field indicates the Isolate setting status.
A bar graph on the right displays the TEXTURE of the SILK processing.
SILK BLUE On SILK BLUE Off
SILK RED On SILK RED Off
■ DELAY field
This field displays the delay status of the corresponding input channel or output channels. Press this
field to open the DELAY popup (12CH) popup window.
1 DELAY ON/OFF indicator
Indicates the on/off status of the delay.
■ INSERT/DIRECT OUT field
2
This field enables you to make insert and Direct Out settings. Press this field to open the INSERT/
D.OUT 1CH popup window.
1
1 DIRECT OUT ON/OFF indicator
(input channels only)
Indicates the Direct Out on/off status.
3
2
INSERT ON/OFF indicator
Indicates the Insert on/off status.
The following indicators indicate the status of the corresponding insert point:
A plug-in, GEQ/PEQ, or outboard unit is inserted at the insert point.
Bypassed.
Level indicator
Gray:
Green:
Yellow:
Red:
■ EQ field
This field indicates the approximate response of the EQ. Press this field
to open the HPF/EQ (1CH) popup window, in which you can set the
HPF, LPF and EQ. This field will be grayed out on channels for which
the EQ is disabled.
■ DYNAMICS 1/2 field
This field displays the threshold value, meter, and abbreviated
dynamics processor type for Dynamics 1/2. Press this field to open the
DYNAMICS 1/2 (1CH) popup window. If GATE is selected as the
dynamics type, an indicator appears, indicating the gate status. If the
dynamics processor is any type other than GATE, the abbreviated type name will appear in this field,
and the threshold setting will be indicated as a horizontal line on the meter. For information on the
abbreviated name and GATE indicators that are displayed, see
1
41
CONTENTS
–∞
<–18 dB
–18 dB≤, ≥0 dB
0 dB<
(page 117).
RIVAGE PM10 Operation Manual
FUNCTION MAP FAQ
1
2