Download  Print this page

Advertisement

CH Parameter  SIGNAL FLOW
1
2
3
4
1
Insert point select buttons
Enable you to select insert points. The following indicators
indicate the status of the corresponding insert point:
A plug-in, GEQ/PEQ, or outboard unit is inserted at
the insert point.
Bypassed.
Level indicator
Green: –18 dB or lower
Yellow: higher than –18 dB to 0 dB or lower
Red:
higher than 0 dB and clipping
2
Level meters
These meters indicate the levels at various points in the signal flow. Levels are detected at the
following locations.
INPUT
• GC GAIN OUT (immediately after the analog gain)
• D.GAIN OUT (immediately after the digital gain)
• EQ OUT (immediately after the EQ)
• DYN1 OUT (immediately after the dynamics 1)
• DYN2 OUT (immediately after the dynamics 2)
• FADER OUT (immediately after the fader)
• ON OUT (immediately after the channel ON)
OUTPUT
• BUS OUT (immediately after the bus)
• EQ OUT (immediately after the EQ)
• DYN OUT (immediately after the dynamics)
• DELAY OUT (immediately after the delay)
• FADER OUT (immediately after the fader)
• ON OUT (immediately after the channel ON)
NOTE
If PEAK HOLD is on, the flow indication will stay red if clipping occurs even once, making it
easier for you to recognize that clipping has occurred.
3
DELAY POINT select buttons (input channels only)
Enable you to select the delay insert point.
4
DIRECT OUT POINT select buttons (input channels only)
Enable you to select the direct out point.
3.
Review the signal flow.
4.
If necessary, review the levels and the location of each insert point.
The settings in this window link with the settings in the INSERT/D.OUT popup window and
the DELAY popup window.
137
CONTENTS
FUNCTION MAP
RIVAGE PM10 Operation Manual
FAQ

Advertisement

Table of Contents

   Related Manuals for Yamaha RIVAGE PM10

Comments to this Manuals

Symbols: 0
Latest comments: