Yamaha RIVAGE PM10 Operation Manual page 153

GEQ/PEQ  Graphic EQ and parametric EQ
The popup window contains the following items.
• CH L>R button
The channel L parameter values will be copied to channel R, and then those parameters will
be linked.
• CH R>L button
The channel R parameter values will be copied to channel L, and then those parameters will
be linked.
• RESET BOTH button
The parameters of both will be initialized, and then linked.
• CANCEL button
Cancels the link and closes the popup window.
3.
Press the GEQ ON/OFF button to turn the 31BandGEQ on.
4.
Press one of the buttons in the FADER ASSIGN field to select the group of bands
you will control using the faders in the Channel Strip section.
The buttons in the FADER ASSIGN field correspond to the following groups of bands.
20-250 Twelve bands within 20.0Hz–250Hz
80-1k Twelve bands within 80.0Hz–1.00 kHz
250-3.15k Twelve bands within 250Hz–3.15 kHz
1.6k-20k Twelve bands within 1.60kHz–20.0 kHz
When you press one of these buttons, the faders for the bands selected on screen will turn
white, and the numbers of the corresponding faders in the Channel Strip section will be
displayed. Also, you will be able to use the faders in the Channel Strip section to control the
corresponding bands.
NOTE
The above operation is possible even if the Channel Strip section is locked. When you turn off
the button in the FADER ASSIGN field, the faders will return to the locked state.
5.
Raise the corresponding fader of the Channel Strip section.
The corresponding frequency region will be boosted or cut.
NOTE
When a fader in the Channel Strip section is set to the center (flat) position, the corresponding
[ON] key indicator will turn off. This indicates that the corresponding band is not being modified.
If you raise or lower the fader even the slightest amount, the [ON] key will light, indicating that
this band is being modified. If you press a lit [ON] key to make it go dark, the corresponding band
will immediately return to the flat state.
6.
Repeat steps 4 and 5 to adjust each band.
NOTE
If you switch the touch screen display to a different screen or to the GEQ window, the fader
assignments in the Channel Strip section will forcibly be defeated. However, if you once again
display the same GEQ, the group of bands you had previously been controlling will automatically
be assigned to the faders.
7.
When you finish making settings, turn off the buttons in the FADER ASSIGN
field.
The faders and [ON] keys in the Channel Strip section will return to their previous function.
NOTE
When you close the GEQ popup window, the buttons in the FADER ASSIGN field automatically
turn off.
153
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual
FAQ