To Stereo - Yamaha RIVAGE PM10 Operation Manual

CH Parameter  TO STEREO

TO STEREO

Controlling via the TO STEREO section
TO STEREO section
1
2
Sending a signal to a STEREO bus
The STEREO buses are used for outputting signals to the main speakers. Signals can be sent to a
STEREO bus in one of two modes, ST mode or LCR mode, and you can make this selection
individually for each channel. These modes differ in the following ways.
■ ST mode
This method allows an input channel or MIX channel to individually send independent signals to
the STEREO A bus and STEREO B bus.
• The signals sent to the STEREO A bus and STEREO B bus can be switched on or off
individually.
• The pan of the signal sent from the input channel or MIX channel to L/R of the STEREO A bus
or STEREO B bus is controlled by the TO ST PAN knob.
1
TO ST [A]/[B] keys
Switch on or off the signal sent from the
input channel to stereo bus A or B.
2 [PAN/BAL] knob
Sets the panning/balance of the signal
sent to the stereo buses.
About MONO
By using the L/R PATH pull-down menu in the
SELECTED CHANNEL VIEW screen, STEREO B
can be set to MONO. If it is set to MONO, the same
signal will be output to L and R of STEREO B.
■ LCR mode
This method allows an input channel or MIX channel to send its signals to the three buses: STEREO
A (L/R) and STEREO B (C) simultaneously.
• The signals sent to the STEREO A bus and STEREO B bus can be switched on/off together.
• The level difference between the signals sent from the input channel or MIX channel to the
STEREO A (L/R) bus and to the STEREO B (C) bus is controlled by the CSR (center/side ratio)
knob.
• The level of the signal sent from the input channel or MIX channel to the STEREO A (L/R) bus
and the STEREO B (C) bus will change according to the settings of the TO ST PAN knob and the
BALANCE knob.
NOTE
• When using LCR mode, set STEREO B to MONO.
• STEREO B is used as the CENTER channel.
1.
Verify that an input source is connected to the channel that you are controlling,
and set the head amp's phantom power, gain, and phase to obtain the optimal
input signal.
2.
Access the TO STEREO popup window, either by pressing the TO STEREO field
knob in the OVERVIEW screen of the input channel or MIX channel whose signal
you want to send to the STEREO A bus and STEREO B bus, or by pressing the
knob in the TO STEREO field of the SELECTED CHANNEL VIEW screen.
134
CONTENTS FUNCTION MAP
L/R PATH pull-down menu in the
SELECTED CHANNEL VIEW screen
RIVAGE PM10 Operation Manual
FAQ