GEQ/PEQ Graphic EQ and parametric EQ
Using the 8BandPEQ
Follow steps 1–6 under
"Inserting a GEQ/PEQ into a
the 8BandPEQ into a channel.
The system displays the EDIT screen for the GEQ/PEQ that you inserted.
EQ type select button
Switches the EQ type to PRECISE, AGGRESSIVE, SMOOTH, or LEGACY.
Displays the parameter values for the PEQ and filters.
PEQ LINK button
Press this button to access the PEQ LINK window, in which you can link the PEQ of paired
The PEQ LINK button appears only for paired PEQs.
Press this button to reset the GAIN parameters of all PEQ band to 0 dB.
All ON buttons for the notch filter will be turned off.
All parameter values other than those above will retain the same values, without being reset.
PEQ ON/OFF button
Switches the currently-selected PEQ on or off.
Press this button to display the EQ graph.
If this button is on, a semi-opaque frequency analysis graph of the input signal (immediately
after EQ) will be superimposed on top of the EQ frequency response graph.
If this button is on, the frequency response graph will indicate and hold the result of the
If this button is on, the analyzed frequency response graph will hold the peak level indication.
• BALLISTICS button
If this button is on, you will be able to add rate of decay to the analyzed frequency response
• FAST/SLOW switch button
Switches the decay rate of graph rendering (FAST/SLOW).
EQ IN/OUT level meters
Indicate the peak level of signals before and after the EQ. For a stereo channel, these meters
indicate the level of both the L and R channels.
LOW SHELVING ON/OFF button
Turn on this button to switch the LOW band to a shelving type filter.
HIGH SHELVING ON/OFF button
Turn on this button to switch the HIGH band to a shelving type filter.
Enables you to bypass bands independently.
EQ parameter setting knobs
Indicate the Q, FREQUENCY, and GAIN parameters for BAND 1–8.
Use the corresponding screen encoder or the [TOUCH AND TURN] knob to adjust the
RIVAGE PM10 Operation Manual