Using Fader Start - Yamaha RIVAGE PM10 Operation Manual

MIDI/GPI  Using FADER START
You can assign the following functions.
Function PARAMETER 1
NO ASSIGN ---
CUE ACTIVE CUE ON
DCA ONLY
INPUT ONLY
OUTPUT ONLY
GPI IN ACTIVE SPECIFIC PORT
IND.
USER DEF. SPECIFIC
KEY ACTIVE NUMBER
IND.
7.
In each field, select the desired function or parameter.
8.
When you finish making settings, press the OK button.
9.
Repeat steps 5 through 8 to specify functions and parameters for other ports.
PARAMETER 2 Description
---- No assignment
A Turns on the [CUE] key of
the selected channel for
B
CUE A/CUE B.
A Turns on the [CUE] key of
the DCA for CUE A/CUE B.
B
A Turns on the [CUE] key of
the input channel for CUE
B
A/CUE B.
A Turns on the [CUE] key of
the output channel for CUE
B
A/CUE B.
PORT 1 – PORT 8 The function assigned to
GPI IN port 1–8 becomes
active.
USER DEFINED The function assigned to
KEY 1 – USER the USER DEFINED key
DEFINED KEY 12 becomes active

Using FADER START

Make FADER START settings if you want a device connected to a GPI OUT port to operate in
tandem with fader operations.
1.
Connect an external device to the GPI connector on the control surface
(CS-R10).
2.
Press the SETUP button on the menu bar to access the SETUP screen.
3.
Press the MIDI/GPI button to open the MIDI/GPI popup window.
This window includes several pages, which you can switch between using the tabs located at
the top of the window.
4.
Press the FADER START tab to access the FADER START page.
4 5 6
245
CONTENTS FUNCTION MAP
7 3
RIVAGE PM10 Operation Manual
FAQ
1
2
8