Download  Print this page

Advertisement

CH Parameter  SENDS TO/SENDS FROM

SENDS TO/SENDS FROM

Using SENDS TO
By using SENDS TO, you can specify the sends to a specific MIX or MATRIX bus for 12 channels at
a time.
1.
Press the [VIEW] key to access the OVERVIEW screen.
2.
Use the MIX/MATRIX SENDS [MIX]/[MATRIX] keys to switch the type of send-
destination bus.
3.
Use the MIX/MATRIX SENDS [1-12]/[13-24]/[25-36]/[37-48]/[49-60]/[61-72]
keys to select a bank of send-destination buses.
4.
Select the SEND knob of the corresponding send-destination MIX/MATRIX bus,
and press it again to access the SENDS TO popup window.
NOTE
When MATRIX channels are selected, pressing the SEND knob again will access the SENDS
FROM popup window
(page
131).
SENDS TO popup window
4
5
6
7
8
4
1
ALL PRE button
Sets the send point to "PRE" for all send sources (input channels, MIX channels, STEREO
channels) of the selected send destination. At this time, the PRE button (5) will light.
2
ALL POST button
Sets the send point to "POST" for all send sources (input channels, MIX channels, STEREO
channels) of the selected send destination. At this time, the PRE button goes dark.
3
Send destination select button
Indicates the currently-selected send desitnation.
You can use the –/+ buttons at left and right to switch to adjacent channels. You can use the
<< / >> buttons to switch in steps of 12 channels.
NOTE
Use the [MIX]/[MATRIX] keys to switch the send-destination selection. You can also switch by
holding down the [SHIFT] key and pressing the meter area display section.
4
Channel select buttons
Indicate the send-source channel being controlled. Press this button to select the on-screen
selected channel. The current channel icon, number, and color appear on the button, and the
channel name appears below the button.
NOTE
You can use the layer select keys to switch the send-source selection.
129
CONTENTS
FUNCTION MAP
1
3
RIVAGE PM10 Operation Manual
FAQ
2

Advertisement

Table of Contents

   Related Manuals for Yamaha RIVAGE PM10

Comments to this Manuals

Symbols: 0
Latest comments: