Yamaha RIVAGE PM10 Operation Manual page 53

System Setup  SYSTEM CONFIG
RY16-DA
OMNI OUT of the control surface
7
1
2
3
4
5
6
1 Patch indication
Indicates the channel that is patched.
2 DELAY button
Switches the output delay on or off.
3 Delay time knob
Sets the delay time of the output port. If you press this knob when it is selected, the DELAY
TIME popup window will appear. The delay time value is shown above the knob in
millisecond units, and below the knob in the units that are selected in the DELAY SCALE
popup window.
NOTE
If the scale is set to ms, the delay time value above the knob will not be shown.
4
PHASE button
Switches the phase of the output signal..
5
GAIN knob
Adjusts the output gain of the output port. You can use the screen encoders to make
adjustments. Adjust the setting in 1.0 dB units by turning the knob, or adjust the setting in
0.1 dB units by turning the knob while pressing it. The current value is shown immediately
below the knob.
6 Level meter
Indicates the output level of the signal after level adjustment.
7 Tabs
Switch the display in units of eight channels.
RY16-AE INPUT1-8/INPUT9-16
AES/EBU INPUT 1-8 of the control surface's rear panel
1
2
3 4
5
7
6
1 Patch indication
Indicates the channel that is patched.
2 Level meter
Shows the input level.
3 SRC button
Switches the sampling rate converter on/off for each pair of channels.
4 Clock status indicator
Indicates the status of the input signal.
53
CONTENTS FUNCTION MAP
8
RIVAGE PM10 Operation Manual
FAQ