Send Point (Output Specifying The Send Point For Each Mix Channel/Stereo Channel) - Yamaha RIVAGE PM10 Operation Manual

System Setup  BUS SETUP
4 POST send point select buttons
Enable you to select the send point for each channels for which PRE is turned off (POST).
These buttons correspond to the following parameters.
Button Send Point
POST FADER Immediately after the fader
POST ON Immediately after the [ON] key
5 SEND TO [+]/[−] buttons
Enable you to select the MIX/MATRIX bus channel as the signal destination for a single
channel at a time.
6
SEND TO [<<]/[>>] buttons
Enable you to select the MIX/MATRIX bus channel as the signal destination for 12 channels at
a time.
4.
Use the send point select buttons to specify the send point.
SEND POINT (OUTPUT)
(Specifying the send point for each MIX channel/STEREO channel)
You can specify the MATRIX bus send point for each bus. The send point can be specified for both
when the send source bus is set to PRE and set to POST individually.
1.
Press the SETUP button to access the SETUP screen.
2.
Press the BUS SETUP button to open the BUS SETUP popup window.
This window includes several pages, which you can switch between using the tabs located at
the top of the window.
3.
Press the SEND POINT (OUTPUT) tab.
The screen contains the following items.
68
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual
FAQ