Bay Selected channel concepts
INPUT [1-72]/[73-144] keys
Enable you to select an input layer.
OUTPUT [MIX]/[MATRIX] keys
Enable you to select an output layer.
Enables you to select a DCA layer.
CUSTOM / keys
Enable you to select a custom layer. You can assign
custom faders of two banks (total of 12 layers) to each
Indicates the selected layer.
Layer Select [A]/[B]/[C]/[D]/[E]/[F] keys
Enable you to select a layer. Different layers are
recalled to the faders depending on the combination of
the keys, as shown in the table below:
CUE A, CUE B,
MON A, MON B
Selected channel concepts
The RIVAGE PM10 system enables you to select a specific channel to control or for which to display
Types of selected channels
The CS-R10 control surface provides four ways to select a channel. This feature enables you to
control multiple channels on a single control surface.
Selecting a channel by using hardware
You can select a channel from the Selected Channel section (hardware).
Selecting channels on screen (up to three individual channels)
You can select one channel each on bay L, bay C, and/or bay R (on the external monitor).
You can also link these selected channels to the one selected by using hardware, if you desire.
Selecting a channel by using a hardware [SEL] key
Hardware [SEL] key
A [SEL] key is used to select the corresponding channel in the Selected Channel section (hardware).
However, in the windows that allow you to assign channels to a DCA or mute group, the [SEL] keys
may be temporarily used for on-screen operations.
Selected Channel section
Exclusively used for
RIVAGE PM10 Operation Manual