Yamaha RIVAGE PM10 Operation Manual page 51

System Setup  SYSTEM CONFIG
4 ALL ON button
If you press this button, all channels not assigned to TWINLANe are selected for assignment in
a single operation.
5 REVERT button
If you press this button, all selections for cancellation or for assignment will revert to their
original state.
5.
Select the channels that you want to use on the TWINLANe network.
When you finish making selections, press the CLOSE button to close the window.
6.
Press the APPLY button to apply the channel settings to the TWINLANe
network.
7.
When you finish making assignments, press the × button to close the SYSTEM
CONFIG [DSP] popup window.
If channels are assigned, and you press the × button without pressing the APPLY button, the
following confirmation screen appears.
If you press OK, all selections for cancellation or for assignment will revert to their original
state, and you will return to the SYSTEM CONFIG popup window.
If you press CANCEL, you will return to the SYSTEM CONFIG [DSP] popup window.
Procedure for the control surface
1.
Press the SETUP button on the menu bar to access the SETUP screen.
2.
Press the SYSTEM CONFIG button to access the SYSTEM CONFIG popup
window.
3.
Press the CS popup button to access the CONFIG [CS] popup window.
1
Parameter settings popup buttons
Press a button to open a popup window, in which you can set the parameters of each card.
2
MY SLOT (1–2) popup buttons
Press a button to open the MY CARD SELECT popup window, in which you can select a Mini-
YGDAI card.
3 HIGH Fs FORMAT selection button
When a Mini-YGDAI card is using high sampling (88.2 kHz, 96 kHz), these buttons select the
operating mode as DOUBLE SPEED, DOUBLE CHANNEL, or SINGLE for IN and OUT
respectively.
NOTE
This function is not applicable if an MY card that does not support high sampling is specified.
The I/Os for the control surface are assigned as part of the DSP engine on the RIVAGE PM10
system. Therefore, you do not need to assign channels to the TWINLANe network.
4.
Set the operating mode for the Mini-YGDAI card's high sampling setting, if
necessary.
5.
When you finish making settings, press the x button to close the SYSTEM
CONFIG [CS] popup window.
51
CONTENTS FUNCTION MAP
3
1
2
RIVAGE PM10 Operation Manual
FAQ