Yamaha RIVAGE PM10 Operation Manual page 69

System Setup  BUS SETUP
1
1 Category select list
Enables you to select the bus category.
2 ALL button
Press this button to apply the selected send point to all MIX/STEREO buses simultaneously.
If the send point is not selected for some channels in the column, "... " will appear.
3 PRE send point select buttons
You can select the send point for each channel. These buttons correspond to the following
parameters.
Button Send Point
PRE FILTER Immediately before the filter
PRE EQ Immediately before the EQ
PRE DYNA Immediately before DYNAMICS
PRE DELAY Immediately before DELAY
PRE FADER Immediately before the fader
2
3 4
4 POST send point select buttons
You can select the send point for each channel. These buttons correspond to the following
parameters.
Button
POST FADER
POST ON
5
6
5 SEND TO [+]/[−] buttons
Enable you to select the MATRIX bus channel as the signal destination for a single channel at a
time.
6
SEND TO [<<]/[>>] buttons
Enable you to select the MATRIX bus channel as the signal destination for 12 channels at a
time.
4.
Use the send point select buttons to specify the send point.
69
CONTENTS FUNCTION MAP
Send Point
Immediately after the fader
Immediately after the [ON] key
RIVAGE PM10 Operation Manual
FAQ