System Setup SYSTEM CONFIG
You can make system settings using the control surface by itself, without connecting a DSP engine or
The procedure for offline settings is described below.
1. Mounting the I/O rack
2. Specifying the type and number of cards
3. Assigning channels to the TWINLANe network
4. Editing the internal parameters of each component
If the settings made while offline differ from the settings of the actual device when the actual device is
connected, the settings of the actual device will take priority over the offline settings, and will be
applied to the system.
■ Mounting the I/O rack
Press the SETUP button on the menu bar to access the SETUP screen.
Press the SYSTEM CONFIG button to access the SYSTEM CONFIG popup
SYSTEM CONFIG popup window
I/O rack select popup buttons (M1–M2)
If you press one of these buttons when an I/O rack is not mounted, the I/O SELECT popup
window will appear, allowing you to select the I/O rack that you want to use. If you press this
button when an I/O rack is already mounted, the I/O rack settings window will appear
Devices being edited offline are indicated as "VIRTUAL" in yellow.
Press the I/O rack select popup button to access the I/O SELECT popup window.
RIVAGE PM10 Operation Manual