Yamaha RIVAGE PM10 Operation Manual page 165

Plug-ins  Controlling the parameters of a plug-in
■ Dual Phaser
Dual Phaser reproduces a vintage phaser that was manufactured during the middle of the 1970s.
Two phasers, two LFOs, and four selectable modes allow a wide range of sounds to be produced.
1 2 5
3 4 8
1
LFO 1 RATE knob
Adjusts the LFO 1 speed.
2
LFO 1 SHAPE switch
Selects the LFO 1 waveform.
3
LFO 2 RATE knob
Adjusts the LFO 2 speed.
4
LFO 2 SHAPE switch
Selects the LFO 2 waveform.
5
PHASER A DEPTH knob
Adjusts the modulation depth of Phaser A.
6
PHASER A FEEDBACK knob
Adjusts the feedback amount of Phaser A.
7
PHASER A ON/OFF switch
Switches Phaser A on/off.
6 7
) !
9 @
#
8 PHASER B DEPTH knob
Adjusts the modulation depth of Phaser B.
9 PHASER B FEEDBACK knob
Adjusts the feedback amount of Phaser B.
)
SWEEP LFO1/LFO2 switch
Selects the Phaser B LFO.
!
SWEEP NORM/REV switch
Selects the LFO phase of Phaser B.
NORM is normal phase, and REV is reverse phase.
@ PHASER B ON/OFF switch
Switches Phaser B on/off.
# MODE knob
Rearranges the two phasers.
I: After mixing the stereo input, the sound processed by Phaser A is output from the
L-channel and the sound processed by Phaser B is output from the R-channel.
II: After mixing the stereo input, the sound processed by Phaser A is output from the
L-channel, and the sound processed by Phaser A is additionally processed by Phaser B
and output from the R-channel.
III: After mixing the stereo input, the sound processed by Phaser A and then by Phaser B is
output from both the L-channel and the R-channel.
IV: The L-channel input is processed by Phaser A and output from the L-channel, and the
R-channel input is processed by Phaser B and output from the R-channel.
165
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual
FAQ