Bay Selected channel concepts
Selecting channels on screen
In addition to the Selected Channel section (hardware), the touch screen in each bay is useful for
controlling parameters for one specific channel. You can specify a channel on each touch screen
based on the channels and parameters selected on screen. The following screens are available for this
• OVERVIEW screen
• SELECTED CHANNEL VIEW screen
• Channel Parameter screen
• PATCH screen, etc.
On these screens, the channel to be controlled is referred to a
channel selected in each screen individually.
The selection status of the channel is displayed in the selected
channel area in the upper-left of each screen.
You can select a channel on screen in one of the following ways:
Press either side (+/– buttons) of
the selected channel indication in
the upper-left of the screen.
Press the left side (–) of the selected
channel indication to select the preceding
channel. Press the right side (+) of the area
to select the next channel.
Press the channel name area
located at the bottom of the screen.
Press the channel name repeatedly to
switch the selected channel on screen.
If you switch fader layers, the channel
name area will change the indication
accordingly. In this way, you can access
any channel on screen.
If you use the [FADER BANK]>[SEL] LINK function specified in the PREFERENCES window,
you will be able to automatically switch to the selected channel in each bank (a channel selected
most recently) while switching between fader banks.
On-screen selected channel displayed on the external monitor
The same principle for the on-screen selected channel applies to the screens displayed on the
external monitor. The monitor will be used for an on-screen selected channel for bay R. In this way,
if you use the external monitor and a mouse, you will be able to operate channel parameters on bay
R in the same way as on bay L and bay C.
RIVAGE PM10 Operation Manual