Ethernet Connection ([Network] Connector) - Yamaha DME64N - Pro Audio Owner's Manual

Ethernet Connection ([NETWORK] Connector)

To control the DME64N/24N from the computer via Ethernet, use an Ethernet cable to connect the [NET-
WORK] connector on the rear panel of the DME64N/24N to the computer, then install DME-N Network
Driver.
N OT E
the "DME Setup Manual" (PDF file)
• Refer to
• Appropriate IP addresses must first be assigned to all devices connected to an Ethernet network.
Two DME series units directly connected via Ethernet
DME64N/24N
You can connect devices in the same device group directly to each other using Ethernet cables, without connect-
ing them to a switching hub. A cross cable is required to connect between DME64N/24N units.
If one of the units is a DME Satellite then either a cross cable or straight cable can be used since the DME Sat-
ellite supports Auto MDI/MDI-X. In this case, set Link Mode on both units to the same setting. Devices in
different subnet (different network address) groups can be connected via a router or layer-3 compliant switching
hub.
SCENE SCENE HOME HOME UTILITY UTILITY LEVEL LEVEL MUTE MUTE CANCEL CANCEL ENTER ENTER
Ethernet Cable
INPUT
PEAK PEAK PEAK
DIGITAL MIXING ENGINE SATELLITE
USB SIGNAL SIGNAL SIGNAL
PEAK PEAK PEAK
SIGNAL SIGNAL SIGNAL
INPUT
DME Satellite
Ethernet Connection ([NETWORK] Connector)
for details on installing DME-N Network Driver.
USB Cable
DME64N/DME24N Owner's Manual
23