Press the tab to access the MONITOR SOURCE popup window.
This window enables you to view the list of monitor sources that have been assigned to
MONITOR SOURCE DEFINE buttons
Each button displays the name of the assigned monitor source. Press these buttons to access
the MONITOR SOURCE SELECT popup window, in which you can assign monitor sources to
individual DEFINE buttons.
Press the desired MONITOR SOURCE DEFINE button to open the MONITOR
SOURCE SELECT popup window, then select the monitor sources.
You can assign up to 8 channel signals to each DEFINE.
Pressing the CLEAR ALL button will clear all selections. You can choose from the following
Input channel 1-44 signals
MIX channel 1-72 signals
MATRIX channel 1-36 signals
STA L, STB L
STEREO A L channel and STEREO B L channel signals
Signals directly input from the external terminals
MONITOR SOURCE SELECT popup window (INPUT)
Monitor source selection buttons
Enable you to select monitor sources that will be assigned to the DEFINE buttons. The selected
monitor sources will be highlighted. Press the same button again to cancel the selection.
You can select up to eight monitor sources. If you select eight monitor sources, no further
selections will be possible. First, turn off the buttons for unneeded sources.
Display switching tabs
Use these tabs to select the type of channels, buses, output jacks, etc. that you want to view on
SET BY SEL button
If this button is on, you will be able to add a channel by using the corresponding [SEL] key.
CLEAR ALL button
Press this button to clear all selections.
Press this button to close the popup window and return to the previous screen.
RIVAGE PM10 Operation Manual