Using Eq - Yamaha RIVAGE PM10 Operation Manual

CH Parameter  EQ

Using EQ

There are three ways to control EQ.
• Controlling the EQ via the Selected Channel section
• Controlling the EQ via the OVERVIEW screen
• Controlling the EQ via the SELECTED CHANNEL VIEW screen
■ Controlling the EQ via the Selected Channel section
EQUALIZER section
2
1
3
4
5
7
6
1 [1-4]/[(5-8)] keys
Switch EQUALIZER parameter settings.
Pressing both [1-4] and [(5-8)] keys
simultaneously will set the gain for all
bands to 0 (FLAT).
2 [ON] key
Switches EQ on or off.
3 [SHELF] key
Switches the shelving filter on/off.
4 Display
Indicates the selected EQUALIZER
parameter.
5 [Q] knob
Specifies the Q value.
6
[FREQUENCY] knob
Sets the frequency.
7
[GAIN] knob
Sets the gain.
1.
Select the channel that you want to edit.
Four-band EQ (HIGH, HIGH MID, LOW MID, LOW) is provided on all input channels.
Eight-band EQ is provided on all output channels. (Control is divided into [1-4] and [5-8]
groups of four bands each.)
2.
If you selected an output channel in step 1, use the [1-4]/[(5-8)] keys in the
Selected Channel section to select the [1-4]/[(5-8)] group of four bands.
3.
Using the [Q] knob (5), [FREQUENCY] knob (6), and [GAIN] knob (7) for each
band in the Selected Channel section, Q, center frequency, and gain for each
band.
4.
If you want to restore the EQ of the currently-operated channel to a flat state,
simultaneously press the [1-4] and [(5-8)] keys in the Selected Channel section.
When you press these two keys simultaneously, the boost/cut amount of all bands will be reset
to 0 dB.
5.
If you want to use the HIGH band or LOW band as a shelving-type EQ, turn on
the [SHELF] key for the corresponding band.
109
CONTENTS FUNCTION MAP
RIVAGE PM10 Operation Manual
FAQ