Using Talkback - Yamaha RIVAGE PM10 Operation Manual

Monitor  TALKBACK
5.
Press a button in the ASSIGN field to specify the input channel(s) or bus(es) to
which the oscillator signal will be sent (multiple selections are allowed).
The buttons correspond to the following buses.
CH1-72 button Input channels 1–72
CH73-144 button Input channels 73–144
MIX button MIX buses 1–72
ST / MTRX button STEREO A bus L, STEREO A bus R,
STEREO B bus L, STEREO B bus R,
MATRIX buses 1–36
MONITOR button MONITOR A, MONITOR A R, MONITOR A C,
MONITOR B, MONITOR B R, MONITOR B C
6.
To enable the oscillator, press the OUTPUT button to turn it on.
The oscillator signal will be sent to the input channel or bus you selected in step 5. When you
press the button again, the oscillator will turn off.
NOTE
You can also assign oscillator on/off or an ASSIGN change to a USER DEFINED key
(page 232).
TALKBACK
As a talkback input, you can select any input port from input patches, as well as the TALKBACK jack
on the top panel of the Control Surface.

Using talkback

■ Controlling the Monitor function via the UTILITY section
1
2
3
4
92
CONTENTS FUNCTION MAP
1
TALKBACK jack
This is a balanced XLR-3-31 jack to
which a talkback mic can be connected.
2 +48V indicator
Lights up when +48V phantom power is
supplied to the TALKBACK jack.
3 TALKBACK LEVEL knob
Adjusts the input level of the mic
connected to the TALKBACK jack.
4 TALKBACK [ON] key
Switches the Talkback function on or
off.
RIVAGE PM10 Operation Manual
FAQ