Download  Print this page

Advertisement

Plug-ins  Controlling the parameters of a plug-in
■ Rupert Comp 830
Rupert Comp 830 is a processor that emulates the compressor section built into the top recording
consoles developed by Rupert Neve during the 1980s.
In addition to providing a broad range of control for Attack and Release, this compressor provides
an EQ and filter on the sidechain, giving you an extremely broad range of tone-shaping possibilities,
and letting you create nearly any sound. The compression is transparent and smooth-sounding, and
can be used on any source in any situation. By using VCM technology, this compressor models a
circuit with a further-evolved audio transformer by Rupert Neve. A shiny, colorful, and well-defined
sound can be obtained simply by routing the signal through this processor.
1
3
9
2
4
)
5
7
8
6
1
HPF ON button
Toggles the sidechain's high pass filter on/off.
2
HPF FREQ button
Adjusts the cutoff frequency of the sidechain's high pass filter.
3
LPF ON button
Toggles the sidechain's low pass filter on/off.
4
LPF FREQ knob
Adjusts the cutoff frequency of the sidechain's low pass filter.
5
MF ON button
Toggles the sidechain's MF band (peaking) on/off.
$
%
!
@
#
^
6
MF FREQ x10 button
Switches the sidechain's MF band (peaking) center frequency to 10 times its value.
7
MF FREQ knob
Adjusts the sidechain's MF band (peaking) center frequency.
8
MF GAIN knob
Adjusts the gain of the sidechain's MF band (peaking).
9
COMP IN button
Switches the compressor on/off.
)
THRESHOLD knob
Adjusts the threshold of the compressor.
!
RATIO knob
Adjusts the ratio of the compressor.
@
ATTACK knob
Adjusts the attack time of the compressor.
#
RELEASE knob
Adjusts the release time of the compressor.
$
AUTO RELEASE button
Toggles the compressor's auto release on/off.
%
GAIN knob
Adjusts the gain of the compressor.
^
Meters
Indicate the input level and the gain reduction.
171
CONTENTS
FUNCTION MAP
RIVAGE PM10 Operation Manual
FAQ

Advertisement

Table of Contents

   Related Manuals for Yamaha RIVAGE PM10

Comments to this Manuals

Symbols: 0
Latest comments: