CH Parameter SENDS TO/SENDS FROM
Switches the send point to PRE or POST for each send-source channel. If a button is lit, the
send point is set to PRE.
SEND ON button
Switches send on/off for each send-source channel.
SEND PAN/BALANCE knob
Adjusts the pan or balance when the send-destination bus is stereo. If the send destination is
monaural or is set to FIXED, this knob does not appear.
If the send source is monaural, the knob adjusts pan.
If the send source is stereo, the knob adjusts balance.
SEND LEVEL knob
Indicates the send level to the selected send destination. You can press this and then use the
screen encoder or the [TOUCH AND TURN] knob to adjust it. If the send destination is set to
FIXED, this knob will not appear.
You can use the SEND ON button to turn on/off the signal that is sent from each
input or MIX channel to the currently-selected MIX/MATRIX bus.
If necessary, use the PRE button to select the send point of the signal that is sent
from each input channel, MIX channel, or STEREO channel to a VARI-type MIX
bus or MATRIX bus.
• You can flexibly select the send point for each channel
• The PRE button is not shown for a FIXED-type MIX bus.
Use the SEND LEVEL knob to adjust the send level.
Using SENDS FROM
By using SENDS FROM, you can specify the sends from a specific channel to the MIX or MATRIX
buses for 12 channels at a time.
Press the [VIEW] key to access the SELECTED CHANNEL VIEW screen.
Press the MIX popup button or the MATRIX popup button to access the SENDS
FROM popup window.
RIVAGE PM10 Operation Manual