Yamaha RIVAGE PM10 Operation Manual page 115

CH Parameter  DYNAMICS
DYNAMICS 1/2 popup window (1ch)
All dynamics parameters can be viewed and edited. This is convenient when you want to make
detailed dynamics settings for a specific channel.
5 6
3
4
7
8 9 )
1
Tabs
Use these tabs to select a channel that you want to view on the screen.
2 DEFAULT button
Press this button to reset all dynamics parameters to the initial values.
3 Dynamics processor type buttons
Enable you to select the dynamics processor type from the following: LEGACY COMP,
COMP260, GATE, DE-ESSER, EXPANDER, DUCKING.
4 A/B switch buttons
Enable you to switch between A and B as the storing destination for the dynamics parameters.
5 Dynamics graph
Displays the input/output response of the dynamics processors.
6
DYNAMICS ON/OFF button
Switches the dynamics processor on or off.
2
1
5
3
4
8 9 )
!
7 Dynamics IN/OUT level meters, GR meter
These meters indicate the peak level of the signals before and after the dynamics processing,
and the amount of gain reduction. For a stereo channel, these meters indicate the level of both
the L and R channels.
8
KEY IN SOURCE select button
Enables you to select one of the following as the key-in signal that will trigger dynamics
processing.
• SELF PRE EQ ................The pre-EQ signal of the same channel
• SELF POST EQ .............The post-EQ signal of the same channel
6 • OTHER PRE EQ...........The signal immediately after the EQ of other input or output
• DIRECT INPUT...........Press this button to access the INPUT PATCH window that enables
9 KEY IN FILTER field
(This area will not appear if DE-ESSER is selected.)
7
Enables you to make various settings for a filter that lets the key-in signal pass.
• Filter select buttons
Select the type of filter from HPF, BPF, or LPF. To
disable the filter, press the button that is turned on.
• Q knob
Indicates the filter Q setting. Use the screen
encoder to adjust the value.
• FREQUENCY knob
Indicates the cutoff frequency of the filter. Use the
screen encoder to adjust the value.
) KEY IN CUE button
This button cue-monitors the signal that is selected as the KEY IN SOURCE. CUE will be
defeated if you select a dynamics processor for which this button is not displayed, or if you
move to a different screen.
NOTE
Even if the Cue mode is set to MIX CUE (the mode in which all channels whose [CUE] key is on
are mixed for monitoring), turning on the KEY IN CUE button will cause only the signal of the
corresponding channel to be monitored. All [CUE] keys that had been turned on at that time will
be forcibly defeated.
! Dynamics parameter setting knobs
Indicate the dynamics parameter values. Use the corresponding screen encoder to adjust the
value.
The type of parameters will vary depending on the currently-selected dynamics processor
type.
115
CONTENTS FUNCTION MAP
channels
you to select the key-in signal.
RIVAGE PM10 Operation Manual
FAQ