Yamaha RIVAGE PM10 Operation Manual page 104

Meters  Using the METER screen
Fader level and meter display
This area displays the meters and faders for each channel.
1
1
Channel number
Indicates the channel number.
Σ clipping indicator
2
Lights to indicate that a signal is clipping at some point in the channel.
3 OVER indicator
Lights to indicate that a signal is clipping at the metering point of the channel.
4 Meter
Indicates the input or output level of a channel.
5 CUE A/B indicator
Indicates the cue status.
6 ISOLATE indicator
Indicates the Isolate mode status.
7 Fader
The channel level is indicated by the fader position and by a numeric value (in dB) that appears
immediately below the fader. If you turn the channel [ON] key off, the corresponding fader
will be grayed out.
NOTE
Press any part of the meter area to recall the corresponding fader layer to the panel.
2
3
4
5
6
7
104
METERING POINT field
You can select one of the following options as the metering point at which the level will be detected.
The metering point for the level meter can be specified independently for input channels and output
channels.
■ For INPUT METER
• PRE HPF
• PRE FADER
• POST ON
■ For OUTPUT METER
• PRE EQ
• PRE FADER
• POST ON
PEAK HOLD button
Turn on this button to hold the peak level indication on each meter. Turn off this button to clear the
peak hold indication. On/off operations of the PEAK HOLD button will apply to both input
channels and output channels. When you turn this button off, the peak level indication that had
been held will be cleared.
NOTE
You can also assign the PEAK HOLD button on/off function to a USER DEFINED key
CONTENTS FUNCTION MAP
(page 232).
RIVAGE PM10 Operation Manual
FAQ