System Setup SYSTEM CONFIG
■ Specifying the number of channels used by the other DSP engine
From the control surface, it is not possible to view or specify TWINLANe network bandwidth
assignment for the DSP engine that is not being controlled by the control surface (subsequently
referred to as "the other DSP engine").
For this reason, the expected number of channels used by the other DSP engine can be manually
entered in advance; in this way you can manage the bandwidth so as not to exceed the maximum
number of channels (400).
Since a TWINLANe network cannot convey data in excess of 400 channels, you must keep the total
number of channels to 400 channels or less.
Press the SETUP button on the menu bar to access the SETUP screen.
Press the SYSTEM CONFIG button to access the SYSTEM CONFIG popup
OTHER DSP button
When you press this button, a popup window appears, in which you can assign the number of
channels used by the OTHER DSP.
Use the knob to specify the number of channels used.
When you finish making the assignment, press the CLOSE button to close the
RIVAGE PM10 Operation Manual